Cisco Access Points
Debug Via SSH or Telnet
To turn on Terminal Monitoring, enter the following command at the Exec Prompt:term monNow you should be able to debug from the SSH session and see the debug information.
Multiple SSID (CLI)
Allow multiple SSIDs to broadcast at the same time:
| Code Block |
|---|
ap(config)# interface d0 ap(config-if)# mbssid ap(config-if)# exit ap(config)# dot11 ssid visitor ap(config-ssid)# mbssid guest-mode dtim-period 75 ap(config-ssid)# exit ap(config)# interface d0 ap(config-if)# ssid visitor ap(config-if)# exit ap(config)# dot11 ssid corporate ap(config-ssid)# mbssid guest-mode dtim-period 75 ap(config-ssid)# exit ap(config)# interface d0 ap(config-if)# ssid corporate ap(config-if)# exit |
EAP Configuration for WAP Enterprise (802.1x)
- Install IAS on a Windows 2003 Server with Certificate Authority or Domain Controller
- Configure Access Point with 802.1x for WPA/WPA2
| Code Block |
|---|
radius-server host RADIUS_IP auth-port 1645 acct-port 1646 key INSERT_KEY aaa group server radius RADIUS_EAP server RADIUS_IP auth-port 1645 acct-port 1646 aaa authentication login EAP_METHODS group RADIUS_EAP dot11 ssid SSID_EXAMPLE vlan 15 authentication open eap EAP_METHODS authentication network-eap EAP_METHODS authentication key-management wpa mbssid guest-mode |