Cisco Access Points

Debug Via SSH or Telnet

To turn on Terminal Monitoring, enter the following command at the Exec Prompt:

term mon

Now you should be able to debug from the SSH session and see the debug information.

Multiple SSID (CLI)

Allow multiple SSIDs to broadcast at the same time:

ap(config)# interface d0
ap(config-if)# mbssid
ap(config-if)# exit
ap(config)# dot11 ssid visitor
ap(config-ssid)# mbssid guest-mode dtim-period 75
ap(config-ssid)# exit
ap(config)# interface d0
ap(config-if)# ssid visitor
ap(config-if)# exit
ap(config)# dot11 ssid corporate
ap(config-ssid)# mbssid guest-mode dtim-period 75
ap(config-ssid)# exit
ap(config)# interface d0
ap(config-if)# ssid corporate
ap(config-if)# exit

EAP Configuration for WAP Enterprise (802.1x)

  1. Install IAS on a Windows 2003 Server with Certificate Authority or Domain Controller
  2. Configure Access Point with 802.1x for WPA/WPA2 
ap(config)# radius-server host RADIUS_IP auth-port 1645 acct-port 1646 key INSERT_KEY
ap(config)# aaa group server radius RADIUS_EAP
ap(config)# server RADIUS_IP auth-port 1645 acct-port 1646
ap(config)# aaa authentication login EAP_METHODS group RADIUS_EAP
ap(config)# dot11 ssid SSID_EXAMPLE
ap(config-ssid)# vlan 15
ap(config-ssid)# authentication open eap EAP_METHODS
ap(config-ssid)# authentication network-eap EAP_METHODS
ap(config-ssid)# authentication key-management wpa
ap(config-ssid)# mbssid guest-mode
  • No labels